Is it pleasant to use window with faulty fittings?
That's right, not really, especially since doing so is not necessary. Our company carries out the following list of services for accessories repair.
Window handle replacement
Before replacing, a layer of paint must be removed, as it prevents direct access to the locking mechanism. Then the bolts and the core of the handle are removed. This is done to diagnose cause of the problem. They can be different, ranging from parts wear, to banal clogging of the mechanism by dust.
Lock replacement
It’s can be done by a similar algorithm. The only difference is that the inner part of the locking mechanism is completely replaced. At the client request, window lock can be mortise, in the form of wrapping without a key or with a key.
Clamping screw replacement
The clamping screw at both ends is equipped with threaded bushings so the work on its replacement is done with a special key. To install the new screw, use a feather drill, as it is necessary to make a hole through the middle horizontal replacement impost inside the frame. After that, with help of a hammer and a wooden attachment, sleeves for it are hammered into designated places. Then long sleeve is attached to the innermost frame part and a short one to the lower outer casement. The clamping screw itself is screwed in by means of a key.
Loop replacement
In case when loops are the same size, you can use old nest. If the size of the loop will be different, you will need to make a new one. In order to remove failed hinges, it is necessary to remove old paint coat from the surface, then unscrew the screws. In especially pipe cases, a hammer and a screwdriver are used as an additional tool. In order to adjust diameter of the holes, you need to expand the holes with a screwdriver or use a cardboard gasket.
Comb installation
In essence, this is a window sash limiter. It is mounted using a thin drill for self-tapping screws or a cross-head screwdriver. During installation, it is necessary to remove window handle, attach a pin to it and place them together in the initial position. After that, it is necessary to mark place for the comb on the window frame. Then, comb is installed in the marked coordinates using self-tapping screws.
Latch installation or replacement
In order to carry out bolt replacement or installation, it is necessary to install a large pad with a locking cylinder on the frame, using self-tapping screws. Then rod extends the entire length of the closure. In parallel with this, it is necessary to attach a smaller pad to the frame, noting its location with a pencil. Completing the installation process and fix it with screws.